BMR Suspension BK004 - Manual

Rear Outer Control Arm Bushings
BK004
Required Tools:
• Hydraulic jack and 2 stands (lift optional but recommended)
• Wrenches – 15mm, 18mm
• Sockets – 18mm, T30 Torx
• Pry-bar
Installation:
1. Lift vehicle and support with stands
under the rocker jack points shown in
Image 1.
2. Remove both rear wheels.
3. Using an 18mm wrench and socket,
remove the outer mounting bolt on the trailing arm then pull down the arm to
provide access to the control arm. See Image 2 below.
1
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
4. Using an 18mm wrench and socket,
remove the lower shock mounting bolt
from the control arm. See Image 3
above.
5. Disconnect the sway bar end-links
using a 15mm wrench and T30 torx
bit. See Image 4.
6. Using an 18mm wrench and socket,
remove the outer mounting bolt on the
control arm and lower the control arm
to provide access to the bushing.
NOTE: it may be easier to put a bottle
jack under the spindle and raise the spindle to gain access to the bushing.