Using the software – Boonton 52000 Series USB CW Power Sensor User Manual
Page 25
Advertising
Boonton 52000 Series
25
Using The Software
This chapter describes how to use the Boonton software when
making typical power measurements. It also provides a description of
the user interface and key features of the software.
Using the software
Once you have installed the software, configured your USB drivers
and connected your hardware, you are ready to make measurements
using the Boonton software.
If you chose the default installation, you should have an icon on your
desktop for the test software. Double-click on this icon to start the
application. Refer to Figure 18 for an example start-up interface.
Figure 1 Default start-up interface
Advertising