Clinton Electronics CE-CP12B - Manual (Page 4)

Hold lower pole section and
turn counter-clockwise to loosen
Prevent lower pole from falling by
holding lower pole section here
Secure assembly by turning collar clockwise:
hand tighten as snug as possible
CAUTION: This mount is intended for use only with the maximum weights indicated.
Use with products heavier than the maximum weights indicated may result in
instability causing possible injury. This product is intended to mount to a steel
support truss, or channel strut.
7/16”
If drilling is nec
essar
y,
U
se 7/16”
metal drill
bit t
o drill thr
ough st
eel
moun
ting sur
fac
e.
Prevent lower pole from falling by
holding lower pole section here
Thread the conduit set-screw
through the hole on the end of the
lower pole.
Conduit set-screw
1/4”-20 Lock Nut
1/4”-20 socket
head allen bolt
1/4” Washer 1/4” Washer
3/4” Conduit Set-Screw Connector
(included with Clinton Electronics pendant mount)
7/16”
If drilling is necessary,
Use 7/16” metal drill
bit to drill through steel
mounting surface.
Hold lower pole section and
turn counter-clockwise to loosen
Prevent lower pole from falling by
holding lower pole section here
Secure assembly by turning collar clockwise:
hand tighten as snug as possible
CAUTION: This mount is intended for use only with the maximum weights indicated.
Use with products heavier than the maximum weights indicated may result in
instability causing possible injury. This product is intended to mount to a steel
support truss, or channel strut.
7/16”
If drilling is nec
essar
y,
U
se 7/16”
metal drill
bit t
o drill thr
ough st
eel
moun
ting sur
fac
e.
Prevent lower pole from falling by
holding lower pole section here
Thread the conduit set-screw
through the hole on the end of the
lower pole.
Conduit set-screw
1/4”-20 Lock Nut
1/4”-20 socket
head allen bolt
1/4” Washer 1/4” Washer
3/4” Conduit Set-Screw Connector
(included with Clinton Electronics pendant mount)
7/16”
If drilling is necessary,
Use 7/16” metal drill
bit to drill through steel
mounting surface.
Hold lower pole section and
turn counter-clockwise to loosen
Prevent lower pole from falling by
holding lower pole section here
Secure assembly by turning collar clockwise:
hand tighten as snug as possible
CAUTION: This mount is intended for use only with the maximum weights indicated.
Use with products heavier than the maximum weights indicated may result in
instability causing possible injury. This product is intended to mount to a steel
support truss, or channel strut.
7/16”
If drilling is nec
essar
y,
U
se 7/16”
metal drill
bit t
o drill thr
ough st
eel
moun
ting sur
fac
e.
Prevent lower pole from falling by
holding lower pole section here
Thread the conduit set-screw
through the hole on the end of the
lower pole.
Conduit set-screw
1/4”-20 Lock Nut
1/4”-20 socket
head allen bolt
1/4” Washer 1/4” Washer
3/4” Conduit Set-Screw Connector
(included with Clinton Electronics pendant mount)
7/16”
If drilling is necessary,
Use 7/16” metal drill
bit to drill through steel
mounting surface.
CLINTON Electronics
6701 Clinton Road
Loves Park, IL 61111
1.800.447.3306 Sales
1.800.549.6393 Support
1.800.633.8712 Fax
www.clintonelectronics.com