Cyron Lighting HTP2406W2 - Manual (Page 4)

2. CLEANING: Using the wipes provided test a small area to make sure it
does not affect the mounting surfaces. Clean the installation surfaces free of
dust/grease to assure the two-sided tape adheres well.
3. MOUNTING CLIPS: Mounting clips can be secured using the two-sided
tape or ½ inch screws. DO NOT USE SCREWS FOR FASTENING TO
ELECTRONIC DEVICES AND SENSITIVE SURFACES.
CAUTION: Tapes may cause discoloration to some surfaces over time.
Remove one side of the tape liner and apply to the bottom of the clips. Apply
pressure for 5 seconds to assure adhesion. Place clips on the lightbars.
4. LIGHTBAR PLACEMENT: Remove the second side of tape liner. Keep the
tape surface clean. Place the bars in the proper location by pressing on the clips
for 5 seconds. CAUTION: Never press on the clear lens of bars. Lightbars will
get damaged! Note the direction of the wires being routed to the hub.
5. CONTROLLER: It should preferably be installed out of sight, while
planning for the IR sensor (receiver) to be installed in line of sight. REMOTE
needs to be pointed at the IR sensor for operation. Cautions and Common
practices:
Keep the controller and wires away from extreme heat, liquids, and
moving objects.
Low voltage wires can be routed through walls and cabinets as long
as proper care is taken to avoid damages.
DO NOT modify internal components. Tampering with components
and wiring will void factory warranty.
General Wiring Diagram
with optional HTPR ribbon lights