Cyron Lighting HTP2406W2 - Manual (Page 5)

6. POWER UP Plug the power supply into an AC outlet. The plug is polarized
(one blade is wider than the other) as a feature to reduce the risk of electric
shock. This plug will fit in a polarized outlet only one way. If the plug does not
fit fully in the outlet, reverse the plug. If it still does not fit, contact the factory
or a qualified electrician. Never use with an extension cord unless the plug can
be fully inserted. Do not alter the plug.
7. DC JACK Connect the power supply DC cord to the controller DC input.
8. LIGHTBARS: Plug lightbars in the controller ports. The order is which the
lights get plugged in is not important.
Operations_____
Turn the unit on and adjust the light angle by twisting the light bars within the
brackets. Try several angles to achieve the desired results.
Operation of HTW202 controller is simple. Color buttons on the remote
correlate to the colors displayed. Four different color shows STROBE, STEP,
FADE, and COLOR automatically change light colors and patterns with pre-
programmed sequences.
1. The speed of light can be changed using the Up and Down buttons. There
are 5 different speeds available in STROBE, STEP, FADE, and
COLOR modes. Brightness can also be adjusted in 5 steps. This
can only be done when displaying solid colors.
2. There are two buttons under R & G for enabling Soft Mode. First, ensure the
light is off. Press the Off button 5 times (the light should turn on). Next press
the orange button to turn on Soft Mode or the green button to turn off Soft
Mode. Simply turn off the light to save settings.
For Advanced Users Only!
3. Wiring sequences can be altered for products in which the lighting sequence
doesn’t match the remote, (the BRG sequence is selected by default.) First,
ensure the light is off. Next press the off button 5 times (the light should turn
on). Then press Yellow for RGB, Blue for GRB or Pink for BRG (buttons
available on last row). Lastly turn the light off to save.
Optional Settings
Turn LED System ON when an outlet is switched on: Plug the power supply to
a switched power source such as audio receiver’s “Switched Power” or wall
outlet that is controlled by a wall switch. Make sure the outlet is switched on.
Using the POWER button on the controller, make sure the LED System is off.
Press and hold the MODE button for 3 seconds. Now the unit will turn on
automatically every time the outlet is turned on.
LED System remains OFF when an outlet is switched on: In a similar process,
press and hold the PAUSE button for 3 seconds. The system will remain off