EOTech XPS3 User Manual
Page 23
2.1.5
Night Vision Mode On/Off Auto Shutdown
The XPS3 HWS® is compatible with Generation I - III+ Night Vision Devices. At the night vision settings,
the reticle brightness is low enough that when viewed with a night vision device, the reticle image
does not bloom.
1. ON/ Night Vision Mode and 8 Hour Auto Shut Down
Pressing the NV Button (see Fig. 4) will turn the sight ON in Night Vision Mode. The sight will
turn on at Level 4 and automatically shut off 8 hours after the last pushbutton control is used. There
are 10 brightness settings in NIGHT VISION MODE with a dynamic range of 1,280:1.
2. OFF/ Turning Sight OFF
To turn the sight off, press both the UP and DOWN arrows simultaneously. Verify that the sight
shuts off by looking though the heads-up window with the night vision device.
3. TOGGLE/ Between Normal and Night Vision Modes
To toggle between NORMAL and NIGHT VISION MODES, press the NV button. When switching
between modes, the sight will remember the last brightness setting. NOTE: When used with a Night
Vision device, always check to make sure the sight is not turned on before pressing the NV button
to turn on the sight in the Night Vision mode. Otherwise, it will toggle to the Normal mode and sat-
urates the image intensifier.
15