JELD-WEN JII102 Wood Pocket Door Frames - Manual (Page 2)

INSTALLATION INSTRUCTIONS
for Wood Pocket Door Frames (JII102)
2
1. Remove the old
door frame from
the wall. cut back
the drywall to
match the new
opening.
2. Remove the floor
plate and non load-
bearing wall studs.
3. Frame the new
rough opening with
a new header and
jambs as needed.
4. Finish the top track
and face jamb as
desired. attach the
top track to the pre-
assembled pocket
frame. the vertical
split jamb aligns
with top track.
attach with screws.
5. Set pocket frame
and face jamb into
the rough opening.
Shim 4" from the
corners and at 24"
maximum intervals
until square, level,
and plumb.
6. Drive a #10 x 2"
screw through the
pocket frame and
each shim. Remove
the shipping blocks.
7. attach the nylon
guide to the split
jamb with nails.
8. Install the hanger
brackets on top of
the door centered
at 2 1/2" from each
end.
9. Slide the rollers
into the top track.
10. hang the door
in the track. lift
and slide the
hanger bracket
onto the adjusting
bolt head. to
align door, turn
the adjusting
bolt head with
a wrench. When
finished adjusting,
tighten lock
nut down onto
bracket.
Please visit jeld-wen.com/resources for warranty, finishing instructions
and care and maintenance information.
Thank you for choosing
© 2009 JelD-WeN, inc. | JelD-WeN, Reliability for real life and the JW icon are registered trademarks of JelD-WeN, inc., Oregon USa.
all other trademarks are the property of their respective owners.
(06/09)
INStall FRame
New
opening
size
existing
trim
Remove
drywall
Fastening
screw
Nylon
guide
Nail
Shipping block
Screw
Door
2 1/2"
center
on door
hanger
bracket
hanger
bracket
Roller
lock
nut
adjusting
bolt head
top track
existing door
frame
Floor plate
Wall
stud
top track
Pocket
frame
Face
jamb
Rotated
180 o
Vertical
split jamb
Shim
Shim
Shim
Shipping
block
Pocket
frame