MBRP S5328 - Manual (Page 2)

S5328 © 06/13 PAGE 2 OF 4
Removal of Stock System:
1. Apply a penetrating lubricant liberally to all exhaust fasteners, hangers and
rubber insulators.
2. Remove the bolts and springs holding the front flange together and
disconnect exhaust system. Do not discard this hardware as it is used for the
installation. Refer to Figure 1.
3. Remove the hangers from the rubber insulators and remove the exhaust from
the vehicle. If a hoist or hydraulic lift is not being used the tail pipe may need
to be cut to clear the rear axle. Refer to Figure 2.
Installation of MBRP Inc. Performance Exhaust:
1. Slide two of the 5/8” Flatwashers over the bolts previously removed from
the flange and then slide the springs over the bolts. Now loosely attach the
Extension Pipe to the flange using the fasteners.
Refer to Figure 3.
Note: The Extension Pipe will need to be trimmed on some models. Refer to
the illustration below.
2. Install the Muffler onto Extension Pipe using one of the 2 ½” Clamps.
Then install the hanger into the factory rubber insulator. Do not tighten the
clamp at this time.
Refer to Figure 4.
Figure 1
Figure 2
Figure 3
Figure 4