MBRP S5328 - Manual (Page 4)

S5328 © 06/13 PAGE 4 OF 4
7. Move the Driver Side Tail Pipe into approximate position. Using the
factory hole provided in the frame located directly above the tail pipe hanger,
attach the hanger provided using the supplied hardware.
Refer to Figure 9.
Note: Lowering and slightly relocating the spare tire may be required for
installation access as well as hanger clearance.
8. Install and adjust the Exhaust Tips to suit. Tighten the lock bolt located on
each Exhaust Tip.
Refer to Figure 10.
9. Make sure that the exhaust is properly in place before tightening clamps.
Start at the front of the exhaust system and begin tightening all connections.
10. Check along the whole length of the exhaust system to ensure that there is
adequate clearance around the spare tire, fuel and brake lines or any wiring. If
any interference is detected relocate or adjust. Pay particular attention to the
brake flex lines and ABS wiring. Most often these can be kept clear of the
exhaust by loosely tying them back. Different configurations may require a
different method. It is the installer’s responsibility to ensure there is enough
clearance to prevent damage.
Congratulations! You are ready to begin experiencing the improved power, sound and driving excitement of your
MBRP Inc.
performance exhaust system. We know you will enjoy your purchase.
Figure 9
Figure 10