Acroprint ES900 - Manual (Page 34)

18. SETTING THE TIME TABLE PROGRAM
34
30 32
1
Press the [SELECT] button and
position the " " over the "Time table
program" mark.
At that moment, the flashing digit
indicates "Program No.".
(The flashing means it can be changed.) Setting program No. 1
(1) Set the "Day of the week".
Press the [SET] button. At that moment,
the flashing changes from the "Program
No." to the "Day of the week".
In case of example, press the
[CHANGE] button to set at "8". And
then press the [SET] button. At that
moment, the flashing changes from the
"Day of the week" to the "Action".
The time table program function allows I Mark© "*" printing (Irregular registration Mark),
an External Time Signal and a Built-in Buzzer. These functions can be programmed for each
day of the week and each time period. Use the I Mark "*" (asterik prints) to indicate punches
earlier or later than scheduled.
Example 1: The time table program is explained using the following example.
SELECT CHANGE SET
TIME TABLE
PROGRAM
I Mark "*"
OFF
Monday
to Friday
I Mark "* " ON
I Mark "*"
OFF
0:00 9:00 0:00 17:30
The following is time table based on the case above.
• I Mark "*" is not printed for the time period with no program setting.
• Up to 48 programs can be set (Program No. 1 through No. 48).
Program No.
01
02
Day of the week
Mon. - Fri.
Mon. - Fri.
Time
9:00
17:30
I Mark "*"
ON
OFF
Action
Day of the week
Print example: I Mark
JAN 31 8:30
JAN 31 10:00
*
Program No.
2
SELECT CHANGE SET
TIME TABLE
PROGRAM
1.
2.
3.
4.
5.
Day of the week
Monday only
Tuesday only
Wednesday only
Thursday only
Friday only
Day of the week
Saturday only
Sunday only
Monday to Friday
Monday to Saturday
Every day
6.
7.
8.
9.
10.