MJM Yachts 34z Express - Manual (Page 54)

- 54 - 34z
CHAPTER 16
QUICK START GUIDE
1 - Disconnect Shore-side Connections
To disconnect shore power cords, turn off all AC loads on the boat and make
sure the main AC breakers on the AC panel (the double breakers) are all OFF.
Then disconnect the cord at the dock end first. Disconnect the cord at the boat
and close the shore power inlet cover. Ditto for any phone/cable lines.
2 - Set Battery Switches
The battery selector switches are under the companionway step. Turn the engine
start switch and the house battery switch to the ON position. The parallel switch
should be in the OFF position and the generator switch only needs to be ON
when running the generator.
Remember to turn them all OFF when leaving the boat.
3 - Check Engine
It is advisable to check the engine fluid levels before starting the engine. Refer to
the Owner’s Manual for instructions on lifting the bridge-deck and checking the oil
and coolant levels. At this time, turn the fuel selector switch to the desired tank,
or both (see Owner’s Manual for further recommendations).
4 - Check Raw Water Seacock
Make sure that the raw water seacock is in the INTAKE position to supply the
engine with seawater for cooling. It is also advisable, once the engine is started,
to check the exhaust at the transom. You should see a surge of water every few
seconds.
5 - Visually Inspect the Engine Room
While doing other checks, it is a good idea to take a look around the engine
space and the bilges for anything that may be out of place.
6 - Check DC Panel
Check the DC panel to insure that the house bank has a reasonable charge
(12.2V or greater). If there is any problem, now is the time to learn of it. Make
sure the DC main breaker is ON, as well as any other circuits that you might
need in the course of your trip. If you need the searchlight in a hurry, for instance,
it’s better to have the breaker already on. Note that the depth-sounder breaker
acts as its switch, and should be on before the chart-plotter.