Paragon 8080 (120V) Classic Dog - Manual (Page 11)

ASSEMBLING THE TONG HOOK
Comes with:

Two Hex Screws

Two Locknuts
Tools needed:
 1/4” Hex Nut Driver
 11/32” Hex Nut Driver
Directions:
With the classic dog facing you, look for the two holes on the right side of
the machine. The holes on the machine should line up with the holes on
the tong hook. Place the two screws through the holes on the tong hook
and then through the holds on the machine. While holding the screws in
place, attach the locknuts from the inside of the machine until tight. See
figure below.
Inside of Machine View Outside of Machine View