PowerTap SL - Manual (Page 28)

28
T TE ES ST T M MO OD DE E
· Starts when the 't" is selected from the setup menu.
· Lights the interval memory mode "M" icon and small number to left of it.
· Mode scrolls through the different test modes as shown by the number.
· Select generally performs the numbered item unless there is to be other inputs are
being tested for.
·
Pressing Mode and Select together for longer than 2 seconds returns to standard
operation
0 - Model and version.
Displays the model on the middle line and version number on the bottom line.
1 - LCD test.
When Select is pressed all the LCD segments are displayed. Press Select again to return to the
normal screen.
2 - Receiver test signal. (Note the receive icon is displayed.)
The middle line display flashes "88" with each blip of data from the receiver whether valid or not.
3 - Heart rate signal test. (Note the heart icon is displayed.)
The middle line display flashes "88" with each heart rate blip received.
4 - Bike computer wheel magnet sense detect. (Note the MI KM icons are displayed.)
The middle line display flashes "88" with each sensing of the wheel magnet next to the receiver.
5 - Cadence test. (Note the C icon is displayed.)
The top line display shows crank cadence sensor RPM. The middle line flashes "88" with each
pulse from cadence sensor. The bottom display shows cadence RPM value from the hub.
6- Torque information. (Note the T icon is displayed.)
This displays information about the internal workings of the torque readings. The bottom display
is the offset torque value directly sent by the hub torque with no correction applied. The hub
sends a value of approximately 512 as the zero point. The middle line display is the correction-