PowerTap PowerCal 2012 - Manual (Page 2)

CLEANING
• Hand wash with a damp towel and warm
water. Do not submerge sensor.
BATTERY REPLACEMENT
• Using coin or a wide blade screwdriver turn
the battery cap counterclockwise one quarter
turn.
• Remove the battery cap and replace the old
battery with a new CR2032 battery. Ensure the
positive (+) side faces up.
• Install the battery cap by turning it one
quarter turn clockwise.
TROUBLESHOOTING
No power meter found by display.
• Ensure the correct pairing procedure using
the device user manual.
• Change the CR2032 battery.
WARRANTY
In the event that warranty service is required,
original sales receipt may be required.
The PowerCal is warranted to the original retail
purchaser to be free from defects in materials
and workmanship. Warranty coverage is valid
to the original purchaser only and proof of
purchase will be required.
• Electronics
- 1 year
- 2 years (Europe)
THIS WARRANTY DOES NOT COVER:
• Normal wear and tear.
• Any damage, failure or loss caused by
accident, misuse, neglect, abuse, improper
assembly, improper maintenance, or failure to
follow instructions or warnings in User Guide.
• Use of products in a manner or environment
for which they were not designed.
CAUTION!
The manufacturer is not responsible for any radio or
TV interference caused by unauthorized
modifications to this equipment. Such modifications
could void the user authority to operate the
equipment.
LIMITATIONS
The foregoing warranties are in lieu of and exclude
all other warranties not expressly set forth herein,
whether expressed or implied by operation of law or
otherwise, including, but not limited to, warranties
of merchantability or fitness for a particular
purpose. Saris Cycling Group shall in no event be
liable for incidental or consequential losses,
damages or expenses in connection with its
exercise products. Saris Cycling Group’s liability
hereunder is expressly limited to the replacement of
goods not complying with this warranty or, at Saris
Cycling Group election, to the repayment of an
amount of the purchase price of the exercise
product in question. Some states do not permit the
exclusion or limitation of implied warranties or
incidental or consequential damages, so the
preceding limitations and exclusions may not apply
to you.
PROCEDURES
Warranty service will be performed by Saris Cycling
Group or an authorized Saris Cycling Group Dealer.
The original purchaser must provide proof of
purchase. Service calls and/or transportation to and
from the Authorized Saris Cycling Group Dealer are
the responsibility of the purchaser.
• Saris Cycling Group will have the option to repair
or replace any product(s) which requires warranty
service.
• Saris Cycling Group will replace any unit that is
structurally defective with a new unit or replace the
unit with a unit of equal value.
• In the event a product cannot be repaired, Saris
Cycling Group will apply a limited credit
reimbursement toward another CycleOps PowerTap
product of equal or greater value.
FCC STATEMENT: This equipment has been
tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and on,
the user is encouraged to try to correct the
interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV
technician for help.
To assure continued compliance, any changes or
modifications not expressly approved by the party
responsible for compliance could void the user’s
authority to operate this equipment. (Example-
use only shielded interface cables when
connecting to computer or peripheral devices).
This device complies with FCC radiation exposure
limits set forth for an uncontrolled environment
and it also complies with Part 15 of the FCC RF
Rules. This transmitter must not be co-located or
operating in conjunction with any other antenna
or transmitter. Operation is subject to the
following two conditions:
(1) this device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
CycleOps 5253 Verona Road Madison WI 53711 608.274.6550 www.cycleops.com 20048D 3/12