Powerwinch Deck Mate 25 - Manual (Page 9)

9
Operating Instructions and Replacement Parts List Deskmate 25 Free Fall Pontoon Windlass
Installing The Switch On The Winch Cover
1. Locate rocker switch in parts pack and assemble
into switch plate as shown in Figure 16.
Step 4. Installing the switch and wiring the winch to the
battery. (continued).
Figure 16. Switch Plate Assembly
Rocker Switch
Switch Plate
Rear view of switch.
Make sure angled
terminals are located
as shown.
Top of Switch
Plate
2. Locate push button switch for light and rubber
boot that fi ts over switch and assemble as shown in
Figure 17.
Switch Boot
Push Button
Switch
Figure 17. Light Switch Assembly.
Insert push button switch through hole in switch
plate and secure with switch boot.
7. After the wiring has been installed as shown in Fig-
ure 15, place the switch plate assembly into the hole cut
in the panel and mark the holes for the switch plate as
shown in Figure 16. Drill pilot holes with a 1/8” drill
bit
Mark these
holes and drill
through with a
1/8” drill bit
Figure 16. Switch Plate Assembly
8. Secure switch plate to helm using screws supplied in
kit at shown in Figure 17.
Secure switch
plate using
screws in kit
Figure 17. Securing switch plate to helm