Ridetech 13076799 - Manual (Page 3)

1. Raise vehicle to a safe and comfortable working height supported by jack stand. Let the
suspension hang freely.
2. Remove the leaf springs and shocks while supporting axle.
1. The factory exhaust hangers need to
be cut off and ground smooth for upper
bridge clearance.
2. Drill and tap a 3/8”-16 hole directly in
the center of the two OEM bump stop
holes. This is the location for your new
shorter bump stop.
3. Install the upper bridge assembly
between frame rails. The bridge will be
indexed by the front hole in the bottom of
the bridge aligning with the rear OEM
bump stop hole. Drill the remaining 5
holes with a 5/16 drill bit. Secure with
supplied 3/8” x 1” self-tapping bolts.