Ridetech 13076799 User Manual
Page 4
4. Bolt lower bridge assembly to axle
using 5/8” x 6-1/2” bolts.
The bolt in the upper bracket will align
the bridge with leaf spring alignment pin.
Tighten the bolts evenly.
5. Align frame bracket with the hole in
the leaf spring hanger. Drill remaining 2
holes. Use the 7/16” x 1” bolts to
secure.
6. Install upper and lower bars using the
5/8” x 2-3/4” bolts supplied. The lower
front bar uses the factory bolt. The
upper bar is slightly shorter.
Note: The exhaust may need to be
modified, or a turndown may be
installed.
7. Remove the top 6 bolts on the axle
cover. Place the panhard bar axle
bracket over these 6 holes and tighten
the 5/16” x 1-1/2” bolts supplied to
factory specs.
8. Attach the panhard bar Heim end to
the axle bracket using the 5/8 x 2-1/2”
bolt. Use the 5/8 x 2-3/4” to fasten the
rubber end to upper bridge.
Note: The axle vent tube may need to
be shortened.