Ridetech 12226799 - Manual (Page 4)

9. Install panhard bar frame bracket using the attachment bolts for the drivers side upper airspring
bracket.
10. Install the panhard axle bracket to the rearend cover using our supplied hardware.
11. Remove factory carrier bearing bracket and install our supplied mounting plate. This will properly
realign the driveshaft for the newly lowered stance.
Drivers side upper airspring bracket. The 2 bolts on
the right side of this bracket will go into the holes
vacated by the oem rear overload bracket. The
remaining holes will be drilled. The 4 holes on the left
side of this drivers side bracket will also attach the
panhard bar frame bracket on the inside of the
framerail.
Also note the removal of the oem bumpstop and the
installation of our shorter bumpstop.
Panhard bar frame bracket on drivers side inner
framerail. This bracket uses the upper airspring
bracket attachment hardware. Panhard bar axle bracket. Be sure to use our
supplied attachment hardware.
6. Install upper and lower 4 link bars.
7. After both AirBar assemblies are installed, The upper
airspring brackets will be installed. There is a left and right
bracket. These brackets are indexed on the 2 front holes of
the rear overload bracket. There will be 2 holes in each
bracket that will align the brackets. The remaining holes will
be drilled in the frame.
8. Remove the oem bumpstop and install our shorter
bumpstop.