Ridetech 12087199 - Manual (Page 3)

3
8. The lower axle mount will bolt to
the leaf spring pad via the supplied U
bolts.
Note: To ease the rest of the install;
leave all bolts loose until the lower
bars are in place.
6. This T bolt will be inserted from
the inside of the vehicle down
through the factory shock hole. A
5/8” nyloc and flat washer will hold
the cradle up tight to the bottom of
the car.
Note: Cars equipped with the “Drag
Pack” option will have staggered
shocks. You will have to remove the
plate covering the original shock hole.
7. Tighten all the upper cradle bolts.
5. The front of the cradle locates off
of the pinion snubber mount. A
reinforcement plate is supplied and is
installed on the inside of the car
with
the bolt threads pointing up. It is
held in place by two 5/16” bolts with
lock washers and flat washers. Two
additional 7/16” holes must be drilled
through the floor pan. 7/16” x 1 ¼”
bolts, Nyloks and flat washers are
supplied
Note: Inspect the factory welds
holding the pinion snubber mount to
the floor pan, re-weld if necessary.