Ridetech 12087199 - Manual (Page 6)

6
17. Once all of the angles are set, tack
weld the upper tabs to the axle. To avoid
frying the bushing remove the upper bar
first then weld solid.
18. Install upper bars. With the vehicle at
ride height snug all 4 link bar bolts.
19. Apply thread sealant to the air fitting
and screw it into the top of the
Shockwave. Bolt the Shockwave into
place using
1/2" x 2 1/4" bolts with nylocs.
20. The installation is complete but you
want to check clearance of the brake lines,
parking brake cables, vent tubes and
exhaust. For the exhaust you can either
install a turndown or reroute the exhaust
under the axle.
21. Ride height air pressure should be
around 75-80 psi.