Ridetech 11446799 - Manual (Page 5)

8. Install panhard bar bracket on rearend housing. BE SURE TO USE THE FASTENERS SUPPLIED
WITH OUR SYSTEM!! The oem fasteners will be too short!
9. Install panhard bar and raise rearend up to ride height. With the axle at ride height, check to make
sure the axle is centered with the frame. The measurement from drum to frame [or some other fixed
points] on each side should be EQUAL! Adjust panhard bar as needed. NOTE: THIS PROCESS
MUST BE DONE AT HIGHWAY RIDE HEIGHT!!
10. Install airsprings into mounts. Be sure to check for airspring clearance at all suspension heights.
REMEMBER: THE AIRSPRING MUST NOT RUB ON ANYTHING AT ANYTIME!!!
Panhard bar axle bracket. Be sure to
use the fasteners supplied with our
system.
11. Install shocks into oem
mounts
.