AMX DTMF+ Interface AXB-DTMF+ - Manual (Page 22)

Programming
18 AXB-DTMF+ DTMF+ Interface
Axcess Program Example
To program the AXB-DTMF+, you will need a personal computer with the Axcess software
program, an Axcess Central controller, an AXlink power/data cable, as well as an CC-COM Axcess
programming cable. For the program example, complete the following steps:
1. Create a new Axcess program. Then, add the following Axcess programming data from the
following example into the Define_Start section of the new Axcess program.
2. Compile the Axcess program and download it to the central controller to program the AXB-
DTMF+.
PROGRAM_NAME='REDIAL'
(* DATE:04/15/96 TIME:15:04:04 *)
(********************************************************************)
(* REDIAL.AXS *)
(* THIS PROGRAM IMPLEMENTS AN AUTOMATIC DIALER THAT DIALS *)
(* A NUMBER IN RESPONSE TO A BUTTON PUSH ON A KEYPAD. IF THE *)
(* NUMBER IS BUSY, THE USER IS NOTIFIED VIA A RS232 TERMINAL *)
(* ATTACHED TO THE SERIAL PORT ON THE MASTER, AND THE CARD *)
(* WILL RETRY 6 ADDITIONAL TIMES AT 5 SECOND INTERVALS. IF THE *)
(* DIALED NUMBER RINGS, THE USER WILL BE NOTIFIED VIA A RS232 *)
(* TERMINAL ATTACHED TO THE SERIAL PORT ON THE MASTER *)
(* *)
(* NOTE THAT TO DEMO THIS PROGRAM, A MASTER, A AXB-DTMF+, *)
(* A PC RUNNING AXCESS, AND A PHONE LINE ARE ALL THAT ARE *)
(* NECESSARY (IN ADDITION TO AN AXCESS CARDFRAME). *)
(* *)
(* MODIFY THIS PROGRAM WHERE THE COMMENT "(* INSERT DESIRED *)
(* NUMBER HERE IN PLACE OF 555-1212 *)" IS WRITTEN. REPLACE THE *)
(* NUMBER 555-1212 WITH THE NUMBER THAT IS DESIRED TO BE CALLED. *)
(* *)
(* AFTER THE PROGRAM HAS BEEN DOWNLOADED TO THE *)
(* MASTER CARD, HIGHLIGHT THE LINE "PUSH[128,1]" AND PRESS *)
(* CONTROL 'A ' ON THE PC KEYBOARD. THEN, PRESS F4 TO ENTER THE *)
(* TERMINAL PROGRAM. PROGRESS MESSAGES FROM THE MASTER *)
(* SHOULD BE SEEN. *)
(*********************************************************************)
(*********************************************************************)
(* DEVICE NUMBER DEFINITIONS GO BELOW *)
(*********************************************************************)
DEFINE_DEVICE
DTMF_CARD = 96 (* AXB-DTMF+ *)
(*********************************************************************)
Distinctive Ring Send_Commands (Cont.)
Command Description
PY_Z-XXX The remaining Ring Patterns and Parts Send_Commands are used just like the
examples shown for Pattern 1 above. Refer to Figure 12 and the following infor-
mation.
• Y = Pattern number
• Z = Part number
• X = Time increment
Continued