Ridetech 13084099 - Manual (Page 3)

9. Place the air spring into the coil
spring pocket with the 3/8” stud
sticking through the 4” washer.
Fasten the assembly with a 3/8”
Nylok nut and flat washer.
10. Slide the bottom of the air spring
over the coil spring retainer.
Note: The bottom of the air spring is
not fastened to the axle. Leave at
least 15 psi in the air springs when
lifted the vehicle by the frame.
6. Place the 4” washer on top of the
upper coil spring mount.
7. Screw the 3/8” x 2” stud into the
top of the air spring.
8. Slide the upper air spring mount
over the 3/8” stud. This mount is
required to fasten the air spring to
upper coil spring pocket.