Ridetech 11284099 - Manual (Page 2)

*****For use w/ RideTech shock kit*****
1. If you have a large hole in the coil
spring retainer you will need to place
the large upper washer on top of the
frame to attach the upper cup bracket.
2. You will need to drill a hole in the
upper coil spring pocket to route the
airline through. Remove all burrs and
use a grommet.
3. Apply thread sealant onto the air
fitting and screw into the air spring.
Place the upper cup bracket onto the air
spring and secure with two 3/8” Nylok
and flat washers. Thread the 6” stud
into the nut inside the cup.