Ridetech 11281099 - Manual (Page 2)

Installation Instructions
*****For use w/ RideTech front shock kit*****
2. The coil spring pocket will need to
be trimmed for air spring clearance as
shown in the picture.
3. Apply thread sealant onto the air
fitting and screw into the air spring.
4. Place one of the cup brackets onto
the top of the air spring and secure
with two 3/8” nyloc with flat washers.
5. Thread 7/16” x 8” all thread stud
into the nut inside the cup.
1. Place the lower air spring plate onto
the lower control arm as shown in the
picture. This is the Drivers side with
the shock mount to the rear of the
control arm. The plate will index off the
rear strut arm bolt. The other two
holes must be drilled for 3/8” x 1 1/4"
bolts. Install flat washers and Nylok
nuts.