Ridetech 11281099 User Manual

Page 3

Advertising
background image





9. Reattach the tie rod, spindle, and sway bar. Refer to a factory service manual for proper
assemble procedure.

10. The sway bar end link may be shortened to achieve proper clearance. This can be done by
shortening the end link and bolt.

11. Double check the air spring clearance through full suspension travel. This air spring should be
approximately 5” tall at ride height. This should be around 100psi.

IT IS THE FINAL RESPONSIBILITY OF THE INSTALLER TO MAKE SURE THE AIR SPRING
DOES NOT RUB ON ANYTHING AT ANYTIME!!!

6. Install the air spring assembly into
the coil spring pocket with the all
thread protruding through the factory
shock hole. The fitting access hole will
be clocked towards the outer tie rod
end. Fasten with 7/16” Nylok and flat
washer. The airline must be routed at
this time.

7. Secure the air spring to the lower
plate use a 3/8” x 3/4" bolt, lock
washer, and flat washer.

8. Place a jack under the control arm
and fully compress the air spring to
double check air spring clearance.

Advertising