Ridetech 11251099 User Manual
Page 2
Installation Instructions
1. Raise and support car at a safe, comfortable working height. Let the front suspension
hang freely.
2. Remove coil spring, shock absorber and strut tower reinforcement plate. Refer to factory service
manual for proper disassembly procedure.
*** Must Use RideTech Front Shock Kit ***
3. Place the lower air spring mount
on top of the upper control arm. Drop
two 3/8” x 1” carriage bolts through
the plate and existing holes in the
upper arm. Tighten with nyloc nuts
and flat washers.
4. Apply thread sealant to the air
fitting and screw it into the top of the
air spring. Place the upper cup on
top of the air spring and fasten with
two 3/8” nyloc nuts and flat washers.
5. Thread the 6” stud into the nut in
the bottom of the cup.
6. Place the cup into the strut tower
with the stud protruding through the
strut tower. The airline access hole
will face the engine.