Ridetech 11251099 User Manual
Page 3
14. Reinstall the strut tower
reinforcement plate. Install the new
bump stop in the factory location. It
may be necessary to trim the inside
edge of the bump stop for air spring
clearance. Check air spring clearance
through full suspension travel.
Allowing the air spring to rub will
cause failure and is not warrantable.
15. Driving height on this air spring is
approx. 5”. This may vary slightly to
driver preference.
7. The upper plate is formed to the
shape of the top of the strut tower. It
will only want to sit in one position.
Use a 7/16” nyloc nut and flat washer
to secure the assembly.
8. With a 5/8” bit, drill a hole in the
strut tower using the upper plate as a
template. This hole will be used as the
new upper shock mount.
9. Insert a 3/8” x 3/4" bolt, flat washer
and lock washer through the lower
plate into the bottom of the air spring.