Ridetech 11171099 - Manual (Page 3)

6. Place the air spring assembly into
the coil spring pocket with the air
fitting facing toward the engine. The
stud will stick through the factory
shock hole. Use the 7/16” Nylok nut
and flat washer to secure the
assembly. The air spring will be held
to the lower plate using a 3/8” x 3/4"
bolt, flat washer and lock washer.
7. The sway bar end link must be
shortened to 1 ¼” long.
8. Double-check air spring clearance
through full suspension travel.
Allowing the air spring to rub will
cause failure and is not warrantable.
9. Driving height on this is spring is 4
½” tall. This should occur around 90
psi but will vary to vehicle weight and
driver preference.