Ridetech 11201099 - Manual (Page 2)

Installation Instructions
1. Raise and support vehicle at a safe, comfortable working height. Let the front suspension hang
freely
2. Remove the coil spring and bump stop. Refer to a factory service manual for proper
disassembly procedure.
3. The outer lip of the coil spring
pocket must be removed for air spring
clearance. This is best done with a
cut off wheel or plasma cutter. Grind
smooth when finished.
If the air spring rubs on the frame it
will damage the air spring. This is a
not a warrantable situation.
4. You must also drill a 7/16” hole in
the top of the coil spring pocket. Use
the hole in the center of the slot as a
guide.
5. Watch for fuel lines and wires on
top of the frame rail!