Ridetech 11114099 - Manual (Page 2)

Installation Instructions
1. Raise and support vehicle at a safe and comfortable working height.
2. Support the axle then remove coil spring and shock. Refer to service manual for proper
disassembly procedure.
*** Must Use RideTech Shock Kit ***
3. Apply thread sealant to a 90
degree air fitting and screw it into the
top of the air spring.
4. Screw the mounting pin into top of
the air spring.
3. To allow the air spring to sit flat on
top of the axle mount, the coil spring
retainer must be cut down to about
¼” tall. Leave just enough of this
retainer to locate the air spring roll
plate, but make sure it is short
enough not to contact the air spring
piston.
Note: Be sure to use the factory
bump stops to avoid bottoming out
the air spring.