Ridetech 11114099 - Manual (Page 3)

5. Place the 4.5” diameter washer on
top of the coil spring pocket, between
the frame and the body.
6. Place the air spring up into the
spring pocket inserting the mounting
pin through the hole in the upper
plate. Secure the assembly with the
large cotter pin.
7. Place the 7.25” air spring roll plate
over the cut down coil spring retainer.
Pull the lower piston down to the
plate.
8. Secure the air spring to the axle
using the D-shaped plate, 3/8” x 1 ¼”
bolt, flat washer and lock washer.
9. Remove the factory shocks and
studs and replace with the new ones
supplied. The larger stud should be
installed into the axle.
10. Check air spring clearance
through full suspension travel.
Allowing the air spring to rub will
result in failure and is not a
warrantable situation.
11. The designed ride height of this
air spring is approximately 10.5” tall;
this should occur around 55 psi but
may vary to vehicle weight and driver
preference.