Ridetech 11329100 User Manual
Page 2
11329100 Installation Instructions
1. This sway bar was designed for use with our lower StrongArms. Installation with other control
arms may require modification.
2. Remove the end links from the factory sway bar. Then remove the bolts attaching the sway bar to
the frame.
3. Bolt the frame plate to the frame
using the factory sway bar holes.
The front hole will use a 10mm x
30mm flat head Allen screw. The
rear hole will use a standard 10mm x
30mm hex bolt.
4. Using the bracket as a guide, drill
the front hole with a 5/16” bit. Then
thread in 3/8” self-tapping screw.
5. Slide the poly bushing over the
bar and lubricate with the lithium
grease supplied.
6. Slide the bracket over the bushing
and fasten the bar to the frame using
the 10mm x 30mm hex bolt and 3/8”
self-tapping screw.
Note: Future lubrication should only
be done with non-petroleum based
lubricants.
PDF created with pdfFactory trial version