Ridetech 11329100 User Manual
Page 3
Advertising
7. Bolt the sway bar arm to the bar
using 3/8” x 1” Button head screws
with flat washers and lock washers.
8. Fasten the 90 degree end of the
PosiLink to the sway bar arm using a
10mm Nylok nut and flat washers
Note: There are two holes in the
sway bar arm. For Shockwave and
CoolRide arms use the front hole.
For coils spring arms use the rear
hole.
9. Two T-bushing will be used on
each side to attach the straight end
of the PosLink to the lower control
arm. Secure with a 10mm Nylok
nut.
10. Check PosiLink alignment
through full suspension travel to
ensure that it does not bind.
PDF created with pdfFactory trial version
Advertising