Ridetech 11289100 User Manual
Page 2
11289100 Installation Instructions
*****This sway bar is designed for use with our front StrongArms*****
1. Slide the sway bar though the
same holes in the frame that the
factory bar went through.
2. Install the new polyurethane
bushing over the sway bar.
Lubricate with the Lithium grease
supplied.
3. Slide the frame bracket over the
bushings and clamp the sway bar
up to the frame using a couple “C”
clamps. The sway bar should be
centered in the hole through the
frame.
4. Adjust the frame bracket so that
the corner of the bracket is flush
with the outside of the frame rail.
5. The factory bolt holes will not be
used. Two new holes must be
drilled with a 3/8” bit.
6. Secure the assembly with two
3/8” x 1 ¼” bolts, flat washers and
Nylok nuts.
PDF created with pdfFactory trial version