Ridetech 11169100 - Manual (Page 4)

9. Attach the other end of the
PosiLink to the sway bar arm with a
3/8” flat washer and a 10mm Nylok
nut.
10. Check sway bar and PosiLink
clearance through full suspension
travel, turning the wheel lock to lock.
Make sure that the PosiLinks do not
bind.
7. Attach the arm to the bar using
three 3/8” x 1” Flat Head Cap
Screws. Blue or Green Loc-tite
must be applied to the threads of
these bolts.
8. The straight end of the PosiLink
will attach to the lower control arm.
A “T”-Bushing must be installed
on each side of the control arm.
Secure the assembly with a 10mm
Nylok nut.
Note: To avoid the front steering
arm bolt hitting the PosiLink, a thin
Nylok jam nut is installed and the
excess threads must be cut off.