Ridetech 11282899 - Manual (Page 2)

Installation Instructions
1. Raise and support vehicle at a safe, comfortable working height. Let the front suspension
hang freely.
2. Remove the coil spring, shock absorber, upper and lower control arms, sway bar and the strut
rods. There is a washer on each side of the lower control arm frame bushing, these will
be reused. The factory lower control arm bolt will be reused as well.
Note: This kit is designed for use with our MuscleBar sway bar. It is easier to install it before
the lower arms. The factory sway bar will not fit.
3. Bolt the lower StrongArm to the frame
using the factory bolt. Be sure to
reinstall the T washers that came off
the factory arm bushing.
4. The front leg of the lower arm will
attach to the frame in place of the strut
rod. Refer to the diagram on the next
page for assembly order.
Note: The hole in the frame may need
to be buffed to allow bearing assembly to
slide in.
5. Using the bearing retainer as a
template; drill three 3/8” holes in the
frame to secure the assembly. Use
three 3/8” x 1 ¼” SHCS and lock
washers to secure the assembly.