Ridetech 11282899 - Manual (Page 3)

6. Attach the Shockwave to the lower
control arm using a ½” x 3” bolt and
Nylok jam nut. An aluminum spacer
must be installed on each side of the
bearing.
7. Two 3/8” x 1 ¼” bolts and nuts are
supplied for the steering stop. They will
bolt to the rear side of the ball joint plate.
This can be adjusted to limit steering
radius.
8. The Caster setting on this system has
a lot of adjustment. We recommend
setting it at 3-3.5 degrees.
9. Driving height pressure should be
around 100psi. 6-8 clicks in the shocks
will be a good starting point. This will
vary to vehicle weight and driver
preference.