Ridetech 11050199 - Manual (Page 7)

When using factory lower arms:
3a. Drill a 1/2" hole in the lower control
arm approximately 7 3/4" from the cross
shaft bolt. Insert the shock stud through
the lower shock eye and then place the
aluminum spacer onto the stud. The
step on the spacer will go into the arm.
Slide the stud through the lower arm and
secure w/ nut and washer.
When using lower StrongArms:
3b. Insert the shock stud through the
lower shock eye and then place the
aluminum spacer onto the stud. The
step on the spacer will go into the arm.
Slide the stud through the tab on the
lower arm and secure w/ nut and
washer.