Ridetech 11050199 - Manual (Page 9)

Installation Instructions
******Must be used w/ RideTech shock kit******
1. Raise and support vehicle at a safe and comfortable working height.
2. Support axle then remove coil spring, shock, and bump stop. Refer to service manual for proper
disassembly procedure.
3. Apply thread sealant to the air
fitting and screw it into the top of
the air spring.
4. Place the upper cup bracket on top
of the air spring and secure with two
3/8” Nylok nuts and flat washers.
5. Thread the 6” stud into the nut in
the bottom of the cup.
6. Place the air spring assembly into
the coil spring pocket with the tab on
the side of the cup aligning with the
factory bump stop mount.