Ridetech 41192000 - Manual (Page 2)

TGR12502 Installation Instructions
• Initial fitment of the floor mount brackets must be done under the carpet. Final installation can
be done under or over the carpet.
• Use Anti-Seize on all fasteners that are threaded into stainless clamps or brackets.
• Install all bars before final tightening.
• Always tighten the tab side of the clamp first.
• Torque all 3/8” fasteners to 45 ft-lbs and all 1/2” fasteners to 75 ft-lbs.
• Make sure the clamp is exactly where you want it before tightening as the clamp may scratch
the tubing.
• Watch for fuel and brake lines when drilling holes through the floor pan.
3. Assemble the clamps to the main
hoop. Use clamp P on the driver
side and clamp D on the passenger
side. Tighten the clamp enough to
be able to position it.
4. Use the ½” x 1 ½” 12 point bolt &
flange nut to fasten the door bars to
the clamps.
5. Position the door bar so that the
bottom of the upper clamp is 11 ¼”
above the main hoop flange. This
should position the door bar just
above the rocker.
1. In order to keep the “T” in the
casting facing up, and the bolts
facing the correct direction, there are
two different direction clamps. Be
very careful as to which clamp halves
you are bolting together. Refer to
the image on page 4 for clamp
locations.
2. A correctly assembled clamp
should look like the one in the picture
shown to the left; there should be a
gap on one side for the tab to slide
into.