Ridetech 41192000 User Manual
Page 3
7. Using the bracket as a template,
drill six 3/8” holes through the floor
pan.
8. Hold the reinforcement plate up
against the bottom of the floor pan.
Drop two 3/8” x 1 ¼” bolts through
the inside two holes. The four outer
holes also pass through the door bar
flange and require 3/8” x 1 ¾” bolts.
The outer rear bolt must be installed
from the bottom up to clear the bar.
Installation complete!
5. To install the front floor pan
bracket, the kick panel must be
removed. To remove the kick panel
the parking brake assembly must be
removed. It will also help to remove
the dimmer switch. There is also a
bolt and clamp that attach the
parking brake to the floor pan that
must be removed.
6. Use the door bar to determine the
location of the floor pan mount. Drill
two 3/8” holes in the kick panel.
Place the reinforcement plate inside
the kick panel and secure the
assembly with two 3/8” x 1 ¼” bolts,
flat washers and lock washers.