Ridetech 41190000 - Manual (Page 10)

Air Ride Technologies
Wire Trough Cover
Scuff Plate
Wire Trough
Body Seam
Upper Tab
Main Hoop Mounting
Bracket (9090)
Lower Tab
C/L Of Mounting
Bracket
SEAT WELL
FOOT WELL
Mounting Hole
Locations
Possible
Preexisting
Hole Location
Reinforcement
Tab (90900)
41190000
8
74-81 Camaro TigerCage
Main Hoop Installation
Step 5. Repeat steps 8 through 14 for
installation of the passenger side package tray
bar Part # 7090 and trunk bar
Part # 70900.
Step 6. Remove the package tray bars and
install the package tray cover. Mark the eight
package tray bar mounting holes and drill the
package tray cover using a 3/8” bit. Reinstall
the package tray bars but Do not tighten yet.
NOTE: Remember to install all bars before
final tightening.
Step 7. Remove all screws attaching the
scuff plate and wire trough cover to the door
sill (See Fig 15). Retain the screws for
reinstallation.
Step 8. Roll back the carpet in the rear seat
exposing the floor pan. Initial fitment of the
main hoop mounting brackets must be done
under the carpet. Final installation can be done
under or over the carpet. Place the driver side
main hoop mounting bracket Part # 9090
on the floor pan with the upper and lower tabs
flush against the wire trough body seam and
floor pan. Center the two inboard mounting
plate holes on the floor pan between the seat
and foot wells (See Fig 16).
WARNING:
When performing step 19 caution
must be taken not to puncture or damage any
fuel or brake lines while drilling through the
floor pan. Remove screws and clamps fasten-
ing the brake or fuel lines to the frame rail or
floor pan allowing them to be moved out of the
way. Both the driver and passenger sides lines
must be moved before drilling.
Step 9. Mark and drill the five mounting holes
using a 3/8” bit (See Fig 17). On some models
the hole in the lower tab of the mounting
bracket will align with a preexisting 5/16 hole
in the floor pan. If this is the case, use the
5/16” x 1 ¼” bolt, Nylok nut and flat washer to
secure the bracket and reinforcement tab
Part # 90900 to the floor pan. Drill pilot
holes first to ensure proper mounting location
of the bracket. We suggest using a center
punch to aid in drilling.
Fig 5
Fig 6
Fig 7