Ridetech 41190000 - Manual (Page 9)

Air Ride Technologies
Package Tray
Bar (# 7090)
Reinforcement
Plate (70909)
Trunk Bar
(7090)
Seat Back
Mounting
Plate
Reinforcement
Plate (709)
Reinforcement
Plate (60908)
Trunk Pan
Trunk Bar
Frame
Rail
/”
7
41190000
74-81 Camaro TigerCage
Main Hoop Installation
Step . Place the driver side trunk bar
Part # 7090 inside the trunk flush against
the seat back. Insert two 3/8” x 1¼” hex head
bolts and washers through the reinforcement
plate Part # 70909, seat back and trunk
bar from inside the vehicle. Secure with two
Nyloc nuts and washers. Do not tighten yet
(See Fig 12).
Step . Align the four holes in the driver side
package tray bar, Part # 7090 with those
in the package tray. Insert four 3/8” x 1¼” hex
head bolts and washers through the package
tray bar, package tray and trunk bar. Secure
with four Nyloc nuts and washers (See Fig13).
Do not tighten yet.
WARNING:
When performing step 13 caution
must be taken not to puncture or damage any
fuel or brake lines while drilling through the
floor pan. Remove screws and clamps fasten-
ing the brake or fuel lines to the frame rail or
floor pan allowing them to be moved out of the
way. Both the driver and passenger sides lines
must be moved before drilling.
Step . Position the inside edge of the
mounting plate 1/2” from the spare tire well
(See Fig 14). Using the trunk bar mounting
plate as a template, drill two pilot holes along
the back edge of the mounting plate. One
through the inboard hole and the other through
the center hole of the mounting plate. The
inboard and center mounting holes should
straddle the frame rail. If necessary adjust the
mounting plate to achieve the proper location
and drill six 3/8” holes through the trunk pan.
Step . Install two reinforcement plates
against the bottom of the trunk pan. The two
hole plate, Part # 60908, is mounted in-
board board of the frame rail and the four hole
plate, Part # 709 is mounted outboard of
the frame rail (See Fig 14). Secure both rein-
forcement plates to the trunk bar using six 3/8”
x 1¼” hex head bolts, twelve washers and six
Nyloc nuts. Do not tighten yet.
Fig 
Fig 
Fig