Acoustic Research AWD211 - Manual (Page 5)

G
ETTING
S
TARTED
5
2. Locate the charging contact
on the bottom of the left
headphone. Line this contact
up with the charging pins on
the transmitter.
3. Place the headphones in the
cradle on top of the transmitter.
The indicator light on top of the
transmitter fl ashes green when
the headphones are charging.
Charging the Headset
If you use the rechargeable batteries provided with the headphones,
you should charge them before you use the headphones for the fi rst
time. The batteries charge when the headphones are placed in the
charging cradle on the transmitter as shown below.
WARNING: To avoid risk of fi re or injury, DO NOT place the
headphones in the charging cradle if you installed alkaline or other
non-rechargeable batteries – this could cause the batteries to leak,
which would damage the headphones.
To charge the headphones:
1. Connect the AC adapter to the power jack on the back of the
transmitter. Then plug the AC adapter into a standard wall outlet or
surge protector.
Note: This power adapter should be plugged in so that it stays
vertical or lies fl at.
Before using your headphones for the fi rst time, let them charge
continuously for 16 hours.
Notes about charging:
• When the batteries are charged, remember to remove the
headphone from charging cradle of the transmitter.
• Never leave the batteries charging for more than 48 hours.
Left headphone,
side view
Charging contact
Transmitter,
top view
Charging pins