Sper Scientific 860031 pH - mV Bench-Top Meter - Manual (Page 15)

15
SETUP MODE
The advanced Setup Mode allows you to customize the
following meter preferences and defaults:
 Memory Transmission
 Clear Memory
 Slope and Offset (pH) or Calibration Review
(Conductivity)
 Buffer Solution (pH) or Cell Constant (Conductivity)
 Temperature Setting (pH)
 Ready Function
 Temperature Units
 Real Time Clock
 Reset
To enter Setup Mode, press SET for more than 2 seconds
while the meter is in Normal Mode.
Note...
To exit Setup Mode without saving, press ESC until Normal
Mode appears. If the meter is in Setup Mode, press ESC
twice to exit. For Conductivity, pH, and mV default settings,
refer to pages 70-71.
Memory Transmission
To transfer stored data from the meter to the computer:
1. Connect a RS232 or USB cable to the rear of the meter,
then connect the other end of the cable with the D-sub
connector to the computer’s serial port. Run the