Tivax LSS-505 - Manual (Page 5)

1. Turn the hand wheel on the side of the sewing machine anticlockwise
to raise the needle to its highest position. Lift the presser foot and
place the fabric you wish to sew under the presser foot (Fig.7).
2. Lower the presser foot (Fig.8).
3. The sewing machine can be operated in two ways: with the foot
controller or with the “power off/speed switch”. To operate the sewing
machine with the foot controller simply press your foot down on the
pedal and to stop sewing at any time simply by releasing your foot from
the controller. Alternatively, when you are ready to start sewing slide
the “power off/speed switch” left to the low (L) position and the sewing
machine will automatically start sewing slide the“power off/speed
switch”right to the high position (H). In order to stop sewing slide the
“power off/speed switch” to the off position (Fig.9).
4. Turn the hand wheel on the side of the sewing machine anticlockwise
to raise the needle to the highest position. Lift the presser foot and pull
out the thread tension release bar, then gently remove the fabric away
from the sewing machine (Fig.10).
5. Cut the thread using the thread cutter.
WARNING: When the sewing machine is in use do not touch the
pattern selection dial.
6
Fig.7 Fig.8
Fig.9 Fig.10
SEWING
Note: Thickness of cloth sewed by this model: 0.3mm
Best to use the machine to sew double layers of cloth, thus every stitch
is available. Best to use No.6, No.7, No.8 stitch to sew soft cloth
(thickness
0.3mm) or silk instead of other stitch patterns.
INSTALLING THE BATTERIES
3
1. Make sure the “power off/ speed switch” is on the “Off” position.
2. Turn the sewing machine over on a flat surface and remove the battery
compartment cover.
3. Insert 4×AA batteries into the compartment and put the battery cover.
CAUTION:
To prevent accidental start up of the sewing machine, always make sure
that the “power off/speed switch” is in the “Off” position when inserting,
or changing the batteries.
CONNECTING THE SEWING MACHINE TO THE MAINS POWER SUPPLY
1. Make sure the “power off/speed switch on the front of the sewing
machine is in the OFF position.
2. Connect the jack (A) to the DC input socket on the back of the sewing
machine,and connect the three-pin plug (B) into the mains power
supply.
3. Connect the foot pedal “C” to the sewing machine by inserting the AC
power jack into the foot pedal input socket on the back of the sewing
machine.
4. To operate the sewing machine you can either use the foot pedal (the
power off/speed switch is in OFF position) for manual operation, or
you can slide the“power off/speed” switch to the left (L) or to the right
(H). Please note that both settings will switch on the sewing machine
and allow automatic operation. The low setting (L) is slow, while the
high setting (H) is fast.
CAUTION:
Whenever the sewing machine is
not in use make sure it is switched
off and unplugged from the mains
power supply.