Turbo Action 70013 CHEETAH SCS Shifter User Manual
Page 5
Part #70013
5
10/93,9/98,1/02,5/06
STEP #33:
Slide the Switch Mounting Bracket underneath the shifter mounting brackets.
Reinstall the bolts into floor, but do not tighten all the way at this time (Fig. #5).
STEP #34:
Note that the switch can slip up and down. In addition, the Switch Mounting Bracket
can be slid forward and back. Before adjusting switch, be sure STEP #29 has
been completed.
STEP #35:
Adjust switch and bracket until both Park & Neutral will allow the vehicle’s engine to
start. Also, double check to be sure the vehicle will not start in reverse or any
forward gear positions.
STEP #36:
Be sure all bolts are secured properly, including the final tightening up of the bolts
mentioned in STEP #33.
STEP #37:
Be sure to add necessary oil before starting. Use popular brand Type “F” fluid!
C4 approximately 3 quarts. C6 approximately 5 quarts.
STEP #38:
Start motor and add transmission fluid until dip stick reads approximately 1 pint low,
or to the “add” mark.
STEP #39:
Take vehicle out and drive normally around the block. Now recheck transmission oil
lever. Add oil if necessary, but DO NOT OVERFILL!
CAUTION:
In a race car it is imperative that the forward gears be precise in relation to
the shifter.
CAUTION! CAUTION!
Be absolutely sure that vehicle is in Park or Neutral Position
before attempting to start motor.