Tuff Country 14058 - GM 07-13 Suburban / Tahoe 1500 4wd 4 lift kit - Manual (Page 13)

49. To begin installation, carefully block the front tires and
wheels so that the vehicle can not roll forward. Safely lift the
rear of the vehicle and support the vehicle with a pair of jack
stands. Place a jack stand on both the driver and the pas-
senger side. Next, remove the rear wheels and tires from
both sides.
50. Working on the driver side, remove the ABS line from the
bottom of the frame rail. Remove the plastic clip and discard.
Repeat procedure on the passenger side.
51. Place a pair of hydraulic floor jacks under the rear differ-
ential. Carefully raise up on the hydraulic floor jacks until
they make contact with the rear differential.
52. Working on the driver side, remove the shock from the
upper and lower location. Save the shock and hardware.
Repeat procedure on the passenger side.
53. Working on the driver side, remove the end link from the
OE mount and sway bar. The sway bar and the lower hard-
ware may be discarded. Save the upper hardware. Repeat
procedure on the passenger side.
54. Working on the driver side, remove the track bar from the
OE track bar mount. Save the hardware for later re-installa-
tion.
55. Carefully lower down both hydraulic floor jacks at the
same time approximately 3”. Special note: Take special
care not to over extend any brake lines and/or hoses.
Working on the driver side, remove the coil spring and set
aside. Repeat procedure on the passenger side.