Tuff Country 14058 - GM 07-13 Suburban / Tahoe 1500 4wd 4 lift kit - Manual (Page 14)

56. Locate the new coil spring spacer and the coil spring
washer. Also, locate (2) 3/8” x 3” bolts, (2) 5/16” USS flat
washers and (2) 3/8” flange nuts from hardware bag
14058NB1. Working on the driver side, install the coil spring
spacer to the upper coil spring pocket using the coil spring
washer on the top of the coil spring pocket and secure using
the new 3/8” hardware. Make sure to use loctite and torque
to 28 ft lbs. Repeat procedure on the passenger side.
57. Working on the driver side, locate and install the coil
spring back into the vehicle. Install the upper portion to the
newly installed coil spring and lower lower portion to the
axle. Carefully raise up on the hydraulic floor jack until the
coil springs seats properly into the vehicle. Repeat proce-
dure on the passenger side.
58. Locate the new rear shock relocation brackets. Locate
(2) 9/16” x 3” bolt’s, (4) 1/2” USS flat washers and (2) 9/16”
unitorque nuts from hardware bag 14056NB3. Install the new
shock relocation brackets to the top of the stock shocks and
secure using the new hardware. Do not tighten at this
point.
59. Working on the driver side, install the modified shock into
the upper and lower location using the OE hardware. Make
sure to use loctite and torque to 85 ft lbs. Move back to the
new 9/16” hardware and add some loctite and torque to 85
ft lbs. Repeat procedure on the passenger side.
60. Locate the new zip tie in hardware bag 14058NB1.
Working on the driver side, zip tie the ABS line to the OE
bump stop bracket. Repeat procedure on the passenger
side.
61. Using the OE hardware, re-install the track bar to the
driver side track bar bracket. Make sure to use loctite and
torque to 85 ft lbs. Special note: If you are not able to per-